Reloading .45 Acp With Titegroup

Glock 37 45 Acp Price 547 USD. The GLOCK 21 gives you everything you would expect of a .45 pistol. New Glock Factory G21SF also for Sale. Firearms must be shipped via Fedex Overnight, to your selected FFL. This is a flat rate, $40 charge. Yes, you can purchase a Glock handgun on this website and have it shipped to
Xd 45 Acp 22 Conversion Springfield Armory sold a 6-inch longslide 1911 called the V16 that was rated for .45 super from the factory. I've heard that some of the V16's came with two (swapable) recoil springs and some came with only one. I didn't particularly like the ported barrel/slide arrangement, so I purchased the regular .45 acp longslide for

Titegroup can be an excellent accuracy powder in many calibers. Even at maximum loadings excessive velocities is not its strong suit in the 45ACP My advice with most of these faster pistol powders is to be patient and use the "work up" rule.

Reloading 45ACP with Titegroup, proper stating.

I grabbed some Titegroup at the local shop yesterday and ran home to work up my first 45ACP rounds. The label on the bottle shows a max load of.

Help with Titegroup for .45 ACP (self.reloading) submitted 5 years ago * by Xhoodlum Dillon 650 – 9mm, .45ACP, .44 Magnum, 5.56/.223, .308 I've been reloading for just over six months and the community here has been invaluable in getting me started.

Take a look at the reloading experiments and science behind finding the right load for suppressed pistols.

Bullseye and Titegroup performed superbly. Bullseye racked in all “1s” in 9mm and scored.

Titegroup load data confusion ? .45 Colt If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed.

I run 4.7 grains of Titegroup with lead 230-grain slugs in 45 acp. No significant leading and other than some scorched brass it is just fine. I loaded some plated Rainier 230-gr bullets with 5.1 grains Titegroup as a +P load and they didn't show any pressure problems or fishbellies. iirc I was using 1.250" oal.

I have been loding Titegroup almost exclusively for all my autoloaders (45 acp, 40, 9mm) and would recommend a charge of no more than 5.0 gr for a 230 gr.

Warning. You must agree to the terms below before continuing. By clicking the 'I Agree' button, I understand/accept and will agree to abide by the precautions and warnings outlined below.

Q&A with Chris Hodgdon of Hodgdon – The Gun Powder People – Editor’s note: While at the SHOT Show earlier this year I had the pleasure of meeting Chris Hodgdon, of Hodgdon, the venerable powder manufacturer.

questions you get from beginners regarding.

Various types of lead boolit lubes produce smoke from the heat. To use the quote from the movie "Josie Wales" – "I don't pay it no mind". My favorite powder for my 9mm has been Unique for years both when I had a semi auto and now my carbine.

First New Technology for Ammunition Cases in Decades; Shell Shock Technologies, LLC. – (Ammoland.com) – Shell Shock Technologies.

NAS 3 cases will not split, chip, crack or grow (stretch) and are fully-reloadable with SST’s custom reloading dies. Testers have reported up to 40.

I grabbed some Titegroup at the local shop yesterday and ran home to work up my first 45ACP rounds. The label on the bottle shows a max load of 5.5gr with a 185 grain bullet. My Hornady manual shows a starting load of 5.5gr with the 185gr XTP and a max load of 6.1gr.

Re: 45 ACP, Autocomp, Titegroup or Power Pistol? Before I started reloading I shot Remington 230g round nose for target and carry Remington Golden Saber 230g. When I started reloading I decided I wanted to load as close to possible to the Remington specs as I could, to keep things the same.

I use Titegroup in my .45ACP for mid-velocity practice loads that are accurate and fairly clean as long as I stick to 4.7gr or more. I don't have a lot of experience with Tightgroup. However I have been using it lately for 230g target loads.

I grabbed some Titegroup at the local shop yesterday and ran home to work up my first 45ACP rounds. The label on the bottle shows a max load of 5.5gr with a 185 grain bullet.

Early preproduction models are 45 percent lighter than brass 5.56mm cases and have.

a velocity standard deviation of 0.093 FPS (124 grain FMJ bullet, 4.2 grains Titegroup powder, 10 rounds, extreme.

Load 45 ACP Without Blowing Up Your Gun .45 ACP Reloading and Load Data (Hodgdon Data) Warning! Notes: Case: Winchester; twist: 1:16"; primer: Federal 150, Large Pistol; barrel length: 5"; trim length: .893.

Press Selection for Reloading .45 ACP Ammunition. From here, you're going to need a press. To load in volume, you need a progressive press. Just how fast a model you buy is a decision between you and your wallet.

Raised, Tritium Filled (Night) Sights – The sights on the CZ 75 SP-01 Tactical Suppressor-Ready Pistol are perfect for suppressed.

a loaded up standard GI 5” barrel 1911 chambered in .45 ACP! As a.

NAS3 cases will not split, chip, crack or grow (stretch) and are fully-reloadable with Shell Shock’s custom reloading dies.

deviation of 0.093 FPS (124 grain FMJbullet, 4.2 grains Titegroup powder,

A Subreddit For Reloading!. use the following search parameters to narrow your results: subreddit:subreddit find submissions in "subreddit"

45 ACP.

of Titegroup (a very fast burning pistol powder) and blew his rifle up, ended up with a split hand, had to sow pieces of his fingers back on, and he took 6 months to recover from his.

Load 45 ACP Without Blowing Up Your Gun.

While this video is focused on pistol cartridges like 45 ACP that have low load density, many of the principles apply to all reloading scenarios.

45 ACP cartridges. A few dollars can be saved buying components in bulk; however, banking real money requires thinking outside the box of conventional reloading.

However, only 4.8 grs. of TiteGroup.

Designed for high performance in semi-automatic pistols and is the powder of choice for 9mm, .40 S&W and .357 SIG. Fast burning and consistent

NAS3 cases will not split, chip, crack or grow (stretch) and are fully-reloadable with Shell Shock’s custom reloading dies.

deviation of 0.093 FPS (124 grain FMJbullet, 4.2 grains Titegroup powder,